anyone have a shaft puller ( nh) they are looking to offload ?
Cheers blurry
anyone have a shaft puller ( nh) they are looking to offload ?
Cheers blurry
PM Chappy
Witb
JBeam Zy-11/Crazy Boron
TM Tour M2 16.5/Kai-Li
Ping G30 7W/Nunchuk
Mizuno MP18 FliHi 3
Mizuno MP18 4-W / Modus 125
Mizuno T7 52
Callaway PM 58
Evnroll ER5
100% on the Chappy ones they are sensational.
Made mine out one of those bench vices, the fold up portable benches with two handles to wind in or out to grip things. I got a piece of angle iron about 4 inches long and drilled a hole the diameter of a shaft, I then cut down from the edge of the angle iron to open up a slot wide enough to take a shaft. This was then bolted to one of the wooden prices that form the top of the bench. You then drop the shaft into the slot with the club head snug to the other side of the angle iron, you then clamp the shaft to the other top timber, so that when you unscrew to open the bench vice, it puts pressure to pull the shaft. Apply heat and keep the pressure up until you see some movement, then completely unscrew to remove the shaft. It ain't fancy but its a cheap puller and it works well.
i have one of these ones up for grabs, near new, hardly used
in the bag
Cleveland Launcher HB Turbo
RBZ tour spoon BT8M3 stiff
HB 910 19deg Matrix O white x stiff
Wilson staff FGV6 Tour Forged irons
wedges trusty tour 50; 54; 58
SC FB no1 or SC red X
and stuff in the pocketsT7M3 S
There are currently 1 users browsing this thread. (0 members and 1 guests)