Lads I have Redtie 7Q3 Reg shaft. It measure 14.5" from the tip to the start of the x on R Flex, how far has it been tipped??
Lads I have Redtie 7Q3 Reg shaft. It measure 14.5" from the tip to the start of the x on R Flex, how far has it been tipped??
Bluu, I don't have any data from Matrix on that shaft. Send this guy an email, he is very helpful:
dsakiyama "at" matrixshafts.com
Then post back what he says and I'll add it to the list. Maybe grab some black tie and white tie numbers while you at it.
Doing some comparison of tipping on some GD shafts with PeteyD this arvo, seems to confirm the above. An AD DI 6X is an inch shorter to the first green ring than a 6S, so a 6S tipped an inch (to give X flex equivalent) will have rings aligning to 6X out of the factory. The shaft in question was tipped half an inch, which is 3 wood tipping spec.
Also checked an AD GT 7S, an ADDJ 6S, an ADDI 7S, and 7X, and all conform to the 24.75" to first green ring measurement principle.
Ad di 6s 24.75 " first green ring
Last edited by Golfwhang; 9th October 2014 at 10:40 AM.
Anyone know the measurements for the black DI7s? The graphics don't align like the BB, GT and MT do!
I need tip to graphics for a Diamana Redboard 83x5ct. Checking online suggests 18 7/8" to the N in Rayon, however a couple of sites say its over 20".
I emailed MRC 2 days ago with no response.
Just heard back from MRC.
Redboard 18.75"
Blueboard 20.75"
to the N in Rayon. This is for the original series shafts.
Diamana D+ 72x5ct. does anyone have a measurement to the N in RAYON? I will email MRC anyway to double-check.
Benno, MRC state 19 5/8" for a Diamana D+ 72 x5ct.
Sticky now applied, and a few shafts added.
There are currently 1 users browsing this thread. (0 members and 1 guests)