X100 Tour Issue vs Project X 6.0

[dR.u]

Hey All,

I’ve been gaming X100 Tour Issues for awhile now and just in the middle of building a new set.

I currently have the Old School Maxfli Australian Blades with the X100s and have just recently bought a set of Kyoei Vega RAF-CM Blades. I’ve seen a few sets of these built with the Project X 6.0 and was thinking of doing the same but, wanted some feedback between the 2 shafts.

I’ve had tried the KBS Ctaper 125 which I found very Boardy.

I also see there’s a new Project X LS shaft out which looks interesting again.

Thanks for your input

Dru

[backintheswing]

X100 to px6.0 is a fair difference in flex I would say. Have you tried Nippon modus125x?

[dR.u]

Someone just mentioned them. I haven’t tried them. He also said the Project X 6.5 would be closer to the X100s than the 6.0. Thanks. I’ll check them out.

[backintheswing]

I have Nippon 125 stiff, play like a s300 but way smoother

[dR.u]

I have Nippon 125 stiff, play like a s300 but way smoother Thanks, you have definitely made me consider the Modus 125x

[scratchoz]

Someone just mentioned them. I haven’t tried them. He also said the Project X 6.5 would be closer to the X100s than the 6.0. Thanks. I’ll check them out.

PX6.5 are a heavier standard stiff like a heavier DG S shaft, definitely don't play near X100, if you can get them, PX7.0 are slightly stiffer than X100 but launch higher and fly a little flatter, I found that they feel very similar and the PX7.0 are a little longer due to the flat trajectory. I loved them when I could swing strong enough to hit them