what bore

[peter_rs]

Does any one know what size/type the TM 540xd tp tour bore is?

I think its .335 parallel

[3oneday]

Tip is usually 0.335.

[peter_rs]

parallel or tapper?

[990B Luva]

0.335 taper i think, can i check without pulling the shaft out of my driver?

[3oneday]

Doesn't apply, taper and parallel are for irons, I haven't previously heard them referred to in woods, it's either a 0.335 or 0.350 tip, unless it's a fatshaft.

Wouldn't be relevant anyway, it's about what length tip is in the tip of the shaft, for trimming purposes.

[peter_rs]

thanks guys

ben helped it was .335 parallel

[3oneday]

So being parallel made a huge difference to you then :confused:

[Jono]

So being parallel made a huge difference to you then :confused:

Bit BORE'd this morning? ;) :lol: