Lh irons, preferably forged with a higher launch shaft than a DG

[GSP]

Standard length preferably

[Daves]

I am presuming in stiff flex? I will check later what I have that would suit, most of my stuff is forged.

[GSP]

Sorry yes, stiff shaft please

[GSP]

Any luck?

[Daves]

Any luck?

Sorry, I haven't had a chance to do a full check as yet. There is a set of Razr X Forged with PX 5.5s. And a set of MP57s, but they have DGS300 in them currently. There is also a set of MDC blades, but I can't remember what shafts are in them. And I may have a spare set of 710CBs, again have forgotten what shafts. I also have a few head only sets that I haven't yet shafted up, plus I have quite a few spare shaft sets, but need to update my listings as I have reshafted a few sets.

[GSP]

No worries mate, let me know, cheers

[Daves]

OK, did a bit of checking and a stocktake to see what I have that might suit you.

The Razr X Forged (4 - PW) have PX 5.5 flighted in them. The 5i is 38.25", D3 SW and 302cpm (at 38", grip on) on my FA. Condition is about 7.5/10 I guess, faces and backs are pretty good, main wear marks are on the soles.

As mentioned I have a set of MP57s (4 - PW), but they have S300s in them. 38.75", D4.5 and 300cpm for the 5i.

I have a set of MDC Tour blades (3 - PW), with unknown brand shafts in them (they have very subtle steps, but no markings). They are set up at 39.0" for the 5i, D2.5 and 293cpm, so about one soft step lighter than S300.

The spare 710 CBs I mentioned, have been soft stepped so are Reg/Firm, not Stiff. Not for sale.

In Heads only, I have a fairly tatty old set of 695MBs (2 - PW), lots of bag and stone chatter, but still plenty of face life.

I also have a set of MacGregor VIP Tourney 1025c (3 - PW) in good condition.