RobNewy
13th March 2012, 09:25 PM
I pulled my PX 6.0 flighted shafts this arvo, and noticed they had a brass plug in the bottom.
I assumed it was to stop the epoxy going up the shsft.
But when i pulled them out, there were 2 different lengths. Short one being 2.5 g and the longer being 3 and a whisker grams.
The PW didnt have one at all.
My new 5.5 non flighted didnt come with any. Are they balance weights? Were should i put them back in?
Pretty certain the heavier ones were in 4-6 iron.
I had already added 8 grams to get them to D5. What will happen?
Cheers
I assumed it was to stop the epoxy going up the shsft.
But when i pulled them out, there were 2 different lengths. Short one being 2.5 g and the longer being 3 and a whisker grams.
The PW didnt have one at all.
My new 5.5 non flighted didnt come with any. Are they balance weights? Were should i put them back in?
Pretty certain the heavier ones were in 4-6 iron.
I had already added 8 grams to get them to D5. What will happen?
Cheers