Buy rattle stop / head tac in Australia?

[reg]

Does anyone know if/who you can buy rattle stop or head tac in OZ?

[Grunt]

Got mine from golfsmith in the us.

[Daves]

Golfworks has it online.

Locally you could try;

http://www.clubmate-golf.com.au/E-comModule/tools-3.php3#adhesives

http://www.onlinegolfcomponents.com.au/accesories.htm

http://www.aussiecustomgolf.com.au/shop/index.php?cPath=93&

Your Pro shop should have some, but probably only for their own use.

[PeteyD]

I think you can use the sticky half of 2 part epoxy.

[reg]

Thanks for replies. Wishing I bought some when I last got some stuff from golfsmith. Can't think of anything else I need to order so it's not worth the shipping. Was hoping someone in Aus sold it or someone knew an equivalent I could get from bunnings.PeteyD, hadn't heard that before. Might try researching and trying it on an old club

[Daves]

Have you tried contacting Virge? He would have some, but again probably only for his own use.

[goughy]

Surely virge would have some spare! He buys it by the 20lt drum.

[virge666]

Surely virge would have some spare! He buys it by the 20lt drum.

Ya think ya funny...

The dark side of the Epoxy will do the same thing. mix a tiny bit of the clear into the large blob of the dark and sqige it down the hosel... shake until the rattle stops, then leave it sitting on the base of the hosel so it sinks in and weights the toe.

Easy

[reg]

Ya think ya funny...

The dark side of the Epoxy will do the same thing. mix a tiny bit of the clear into the large blob of the dark and sqige it down the hosel... shake until the rattle stops, then leave it sitting on the base of the hosel so it sinks in and weights the toe.

Easy

Thanks, I have golfworks epoxy so use the black part? The clear is the hardener?

Back story, was drilling out the hosel plug and a little of it went into the head, there seems to be some factory rattle stop just below the hosel which I think has caught it but I want to make sure it wont move when I put the shaft in, should I sit the clubhead so this epoxy mix will add to the factory rattle stop?