Removing grips to reuse

[retiredozzie]

I want to remove some grips so that I can add some papers to increase their size. As the grips are basically new is there a way to remove them to reuse.I have heard of some pros "popping them off". Any golf shop in Adelaide or suburbs do this? I would install the grips myself. I know most would say it is easier to just renew the grips but I'd like to use my original grips.Thanks.

[GolfBallWhackerGuy]

I got my whole set done at Powergolf. They removed the near new grips, put more papers on the shaft and put back the same grips for $3 per club. Check your local golf shop and see if they can do it for you.

[Veefore]

Find someone with a compressor and blow the grips off. Stick the nozzle in the hole before the pressure gets very high and as the pressure builds the grip will start to bulge. Keep your hand wrapped around it to stop any part of it bulging too much and bursting and after a few moments the grip will pop straight off. Once you get the hang of it it takes only a couple of seconds per grip.

[timinsa]

Hi mate.
It can be harder than veefore describes if you don't know what you are doing.
I'm in Adelaide & can do this for you.
PM me.
I'm in Millswood.

[3oneday]

I know most would say it is easier to just renew the grips
most here would say "buy a new set instead" ;)

[Captain Nemo]

Buy a new set instead!!:mrgreen:

[razaar]

Cut them off.. Jono has 60 grips to "give away".;)