View Full Version : Installing an R9 Tip
morgy
6th March 2010, 10:51 PM
Trying to buy a new shaft for my R9, is it difficult to install an R9 tip onto a shaft? How is it done? Is it something I should get a pro to do?
Cheers.
virge666
7th March 2010, 10:05 AM
I have done a few and it is a piece of piss.
Seriously very easy
You will need a Torx wrench
Hux
7th March 2010, 10:36 AM
I would have thought the tip was glued in place Virge :-)
Captain Nemo
8th March 2010, 10:24 AM
Just glue it on?
virge666
8th March 2010, 03:50 PM
Yep
Tip is glue to the shaft and installed via a torx wrench.
Seriously 3 minute job
3oneday
8th March 2010, 03:59 PM
Wouldn't it go like this Virge ?:
1) Buy Sleeve
2) Buy shaft
3) prep shaft
4) glue prepped shaft to tip.
5) install shaft as one would normally in an R9 ?
Just be careful where you buy your tips, you can buy generic ones from Golfworks or the proper looking ones from a chick on ebay for about $30USD delivered a piece.
Captain Nemo
8th March 2010, 05:02 PM
That's all there is to it 3!
Morgy, not interested in my Grafalloy Prolaunch Red?
I have a spare TP sleeve as well!
virge666
8th March 2010, 09:34 PM
Wouldn't it go like this Virge ?:
1) Buy Sleeve
2) Buy shaft
3) prep shaft
4) glue prepped shaft to tip.
5) install shaft as one would normally in an R9 ?
Just be careful where you buy your tips, you can buy generic ones from Golfworks or the proper looking ones from a chick on ebay for about $30USD delivered a piece.
Sounds good to me.
:)
3oneday
8th March 2010, 10:56 PM
Dumb club anyway.
Captain Nemo
9th March 2010, 10:25 AM
Second that!
Powered by vBulletin® Version 4.1.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.